Have not weighed after removal.
847 Lbs. With foam....
Lectro88
Member
Last Activity: Yesterday, 09:46 PM
Joined: 09-28-2020
Location: Charlotte, NC
-
Made pretty progress today.
Did 1st. Hull weigh.
Got foam out.
did some sanding.
Swept out. Didn’t pressure wash.
Now...Leave a comment:
-
Foam scraped away
Now here in middle pic the ply "looks" not too terrible.. this was the side attached to glass of the transom.
...Last edited by Lectro88; 02-23-2021, 07:01 PM.Leave a comment:
-
A few pics of transom
I discovered today that at bottom of Mitre or step down of transom, there were 2 layers ply, that area was 38-40" wide...Last edited by Lectro88; 02-23-2021, 06:53 PM.Leave a comment:
-
Here are some pics of ants in foam.
in 3rd pic I uncovered a small hole, 2 ants investigated their last crime.
shoved small piece foam in...Last edited by Lectro88; 02-23-2021, 06:48 PM.Leave a comment:
-
[QUOTE=PoleLock;n549966]Lectro...the machine worked like an oversized can opener
Wide open now...let the fun begin! Keep us updated...Leave a comment:
-
Thanks Crodia05.
I have a mountain of work to do.
And being over particular doesn’t help the process of getting done sooner.
...Leave a comment:
-
Leave a comment:
-
Well after many failed attempts, I finally got the Cap separated from the Hull and set off.
Got 2 of my good neighbors to lend a hand, and with...Last edited by Lectro88; 02-22-2021, 06:40 PM.Leave a comment:
-
If its what you want and don't mind whatever problems that show up.. thats better than great.
From what I have seen, the old Mako's are made outstanding,...Last edited by Lectro88; 02-14-2021, 01:16 PM.Leave a comment:
-
Glad to see the progress. you are doing K.A.. work. (cleaned that up a little bit)
My project has stalled a little, been very rainy and cold...Leave a comment:
-
sent you pm.
I don't claim to be an expert, I'm new on the boat scene too, and finding out with my wallet too.
My project is 2 years(easy)...Leave a comment:
-
Hello Bumside.
There is no way I would give 5k for that boat.
I am rebuilding a 69 19' cc
I gave 900 for it with a 175 evinrude missing... -
I plan to install on my 19' restoration. But a little ways out for time.
Can be found on sleezebay(ebay) free shipping under $500.00 (entire kit)...Leave a comment:
-
This was just a "see if this will work idea."
I pushed the limits and made a tight radius with little to no trouble.
The radius...Last edited by Lectro88; 01-26-2021, 10:48 PM.Leave a comment:
-
Thanks Eric.
I did a miniature prototype stringer mock up today just playing around at the saws,.. and it got out of control.
I may have to...Leave a comment:
No activity results to display
Leave a comment: