Announcement

Collapse
No announcement yet.

Control Cables

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Control Cables

    Have 1984 Mako 21ft. Replacing stolen 200hp Yamaha motor. Need to know cable length for engine controls as they were cut .From engine up the starboard side to center console.
    Jerski

  • #2
    The manual for the 211 under the FAQ/Reference section of this site says 16'
    Dave [br]Woodbury Heights, NJ[br]\'73 Mako 20[br]\'85 Mako 254[br]http://www.classicmako.com/forum/topic.asp?TOPIC_ID=55336[br]http://www.classicmako.com/forum/topic.asp?TOPIC_ID=52586

    Comment


    • #3
      I asked the same question regarding cable lenghts for Mako 250. One reponse suggested looking on the existing cable for lenght. Once I pulled the cables back the lenght was stamped on the cable jacket. The existing cables for 250 are 22ft. The starboard cable route was alittle short so I will purchase longer cable 26ft to allow for some stack.
      Keyman[br]Paoli, PA

      Comment

      Working...
      X